Gravel Garden Path: A Complete Worked Estimate

A full gravel estimate for a 60 square foot garden path laid 2 inches deep, including edging and membrane.

A gravel path is one of the few garden projects where the finished surface is also the simplest material in the build, yet the layers underneath decide whether it stays crisp or turns into a muddy, weed-threaded track within a season. This estimate covers a single path end to end: how much stone the surface needs, what goes beneath it, and the sequence that keeps it looking deliberate.

The path being built

The path covers 60 sq ft in total, or 5.57 sq m. Imagine it running from a garden gate to a shed or side door — perhaps 20 ft long and 3 ft wide (6.10 m by 0.91 m), though any combination giving the same area uses identical quantities. The ground is ordinary garden soil, dug out in advance so the finished gravel sits level with the surrounding lawn and beds rather than perched above them.

The surface depth is 2 in, which is 5.1 cm. That is enough stone to cover the membrane completely and give the characteristic loose crunch underfoot, without being so deep that walking feels like wading and the gravel migrates off the edges with every pass.

Step one: express the depth in feet

Volume needs consistent units, so convert the depth before doing anything else:

2 in ÷ 12 = 0.1667 ft

Write this figure down. Estimates for paths go wrong more often at this small conversion than at any other stage.

Step two: work out the volume

Multiply the path area by the depth in feet:

60 sq ft × 0.1667 ft = 10 cu ft of gravel (0.28 cu m)

Cross-check in metric: 5.57 sq m × 0.051 m gives about 0.28 cu m, confirming the imperial result.

Step three: state it in cubic yards

For anyone comparing a loose bulk load, convert cubic feet into cubic yards by dividing by 27:

10 cu ft ÷ 27 = 0.37 yd³ (0.28 m³)

A fraction of a yard like this is usually below the sensible minimum for a tipped delivery, which is one reason the bagged calculation below tends to govern paths of this size.

Verify other lengths and depths in the Gravel Calculator.

Step four: turn volume into bags

The bags specified for this project each hold 0.5 cu ft:

10 cu ft ÷ 0.5 cu ft per bag = 20 bags

Twenty bags is the purchase figure. It is also a useful reality check on transport: twenty small bags are heavy in aggregate even though each one is liftable, so plan the carrying route from vehicle to path before the delivery arrives, not after.

What goes underneath, and why it is in the estimate

Gravel straight onto soil fails in predictable ways. Stones press into mud, soil pumps up between them, and weeds root in the mixture. Two components prevent that, and both belong on the shopping list alongside the stone itself.

First, edging runs down both sides of the path. On a 20 ft (6.10 m) route that means roughly 40 ft (12.19 m) of edging in total, one length per side, plus the short pieces across the ends if the path terminates against open ground. Edging is what stops the 2 in (5.1 cm) layer from spreading sideways into the beds under foot traffic.

Second, a weed membrane covers the full 60 sq ft (5.57 sq m) of the path bed, laid over a levelled and compacted base and tucked under the edging. Its job is separation as much as weed suppression: it keeps the stone and the soil as distinct layers so the surface stays stone, not a blend.

Full shopping list

Item Quantity needed Buy
Gravel 10 cu ft (0.28 cu m) at 2 in (5.1 cm) deep 20 bags of 0.5 cu ft
Gravel, bulk alternative 0.37 yd³ (0.28 m³) Only if a part-load is available
Weed membrane To cover 60 sq ft (5.57 sq m) plus overlap at joins Enough to cover 60 sq ft plus overlap
Path edging Both sides of the path, about 40 ft (12.19 m) on a 20 ft route Lengths totalling both sides plus ends
Edging pegs or fixings To hold the edging line along its full length 1 pack
Sub-base material, if the ground is soft To form a compacted layer under the membrane across 60 sq ft Enough to cover 60 sq ft
Membrane pegs or staples To pin membrane edges and overlaps 1 pack
Rake and tamper For levelling 10 cu ft of stone and compacting the base 1 set

Order of work

Mark the route with string lines, dig out the path bed to a depth that accommodates the base, membrane, and 2 in (5.1 cm) of gravel while finishing flush with the surroundings, and compact the exposed soil. Install the edging while the trench is open, checking its line and level carefully, because once the stone is in, the edging is the path’s visible geometry.

If the ground is soft, spread and compact a sub-base layer next. Then lay the membrane across the full 60 sq ft (5.57 sq m), overlapping any joins and pinning it so it cannot wrinkle into ridges. Only then tip out the gravel, a few bags at a time, raking it level and checking that the membrane never peeks through — bare patches in the covering will show as dark spots and collect soil. Walk the path, top up the hollows that appear underfoot, and rake once more.

The choice between loose stone and organic coverings for routes like this is compared in mulch vs gravel for paths and beds.

Mistakes specific to this project

Laying gravel too deep is the beginner’s instinct and the experienced gardener’s warning. Beyond about 2 in (5.1 cm) the surface becomes unstable, wheels and heels sink, and stone spills over the edging. This estimate’s 10 cu ft (0.28 cu m) is deliberately modest; more material would make the path worse, not better.

Skipping edging is the second classic failure. Unrestrained gravel travels — into lawns, into beds, and onto patios — and within months the path is thin in the middle and the borders are full of stone that dulls mower blades. The edging line in the shopping list is structural, not decorative.

Third, do not lay membrane over unprepared, lumpy ground and expect the gravel to hide it. A 2 in layer follows the contours beneath it faithfully. Lumps become humps, dips become puddles, and membrane folds can work their way to the surface. Level first, then cover.

Lastly, remember that gravel needs occasional raking back from the ends of the path where feet kick it forward. Choosing angular stone rather than rounded pea gravel reduces that migration noticeably, because angular pieces lock together instead of rolling — a small specification decision that saves years of minor annoyance.


Next step: measure your path's length and width, run it at 2 inches in the Mulch & Gravel Calculator, and price the bulk-bag option against the small-bag count before you order. Paths are where that comparison pays for itself.