Wallpaper a Small Nursery: A Complete Worked Estimate

A worked wallpaper estimate for a small nursery with a 40 foot perimeter, 8 foot walls and a 12 inch pattern repeat.

Nurseries are often wallpapered with a patterned paper chosen for charm rather than convenience, and pattern is exactly what makes wallpaper estimating different from paint estimating. You are not buying area — you are buying usable strips, and the repeat of the design decides how much of each roll survives the cutting table. This example follows one small nursery all the way from perimeter tape to roll count.

The room and the paper

The nursery has a perimeter of 40 ft, which is 12.19 m. That could be a room of 11 ft by 9 ft (3.35 m by 2.74 m) or any other rectangle whose four walls add up to the same circuit; for wallpaper, the perimeter matters more than the individual wall lengths. The walls are 8 ft high, or 2.44 m, measured from skirting top to ceiling line. One door and one window interrupt the walls, but wallpaper estimating handles openings differently from paint, as explained below.

The paper is supplied as a double roll, 33 ft long by 20.5 in wide — in metric, about 10.06 m long by 52 cm wide. Its pattern repeats every 12 in (30.5 cm), and the match is a straight match, meaning each strip must start at the same point in the design as its neighbour.

Step one: work out the cut length per strip

A strip must cover the wall height and then be extended to the next full pattern repeat, so the drop aligns with the strip beside it. Start with the wall:

8 ft = 96 in (243.8 cm) of wall height

Now round that height up to a whole number of repeats. The repeat is 12 in (30.5 cm):

96 in ÷ 12 in = 8 repeats exactly

In this particular room the height happens to divide cleanly, but a trimming allowance still has to be added for the top and bottom of each drop, and the working cut length used for this estimate is:

Cut length per strip: 108 in (274.3 cm), which is 9 ft (2.74 m)

That 108 in figure is the one that determines how many strips a roll can yield. Using the bare 96 in wall height instead would overstate the yield of every roll and leave the final wall uncovered.

Step two: how many strips does the room need?

Strips are counted around the perimeter. Convert the perimeter to inches to match the roll width:

40 ft × 12 = 480 in of perimeter (1,219 cm)

Divide by the width of one strip, which is the roll width of 20.5 in (52 cm):

480 in ÷ 20.5 in = 23.41 strips → round up to 24 strips

Notice that the door and window were not subtracted. Above a door, below and above a window, and beside both, wallpaper is still needed in fiddly pieces that are cut from full strips. Deducting openings the way a paint estimate does would undercount a papered room, so the full circuit is covered and the openings are absorbed within the strip count.

Test other perimeters and repeats with the Wallpaper Calculator.

Step three: strips per roll

Divide the roll length by the cut length, working in the same units. The roll is 33 ft, which is 396 in (1,006 cm):

396 in ÷ 108 in per strip = 3.67 strips → 3 usable strips per roll

The fraction cannot be used. A fourth strip of only partial length will not reach from ceiling to skirting, and its pattern segment may not even contain the right part of the design. Three full strips per roll is the honest yield, and the leftover piece goes toward the short lengths needed above the door and window.

Step four: rolls to buy

Divide the strips needed by the strips each roll provides, rounding up:

24 strips ÷ 3 strips per roll = 8 rolls exactly

Buy 8 double rolls.

An exact answer carries a warning. There is no spare roll in this count for a torn strip, a mis-measured cut, or a section that has to come off and be redone. If the paper is a standard stock design, consider holding a ninth roll unopened as insurance and returning it if the shop’s policy allows; if it is a short print run, that extra roll may be the only way to guarantee a dye-lot match later.

Full shopping list

Item Quantity needed Buy
Wallpaper, double rolls 33 ft × 20.5 in (10.06 m × 52 cm) 24 strips at 108 in (274.3 cm) cut length 8 rolls
Wallpaper paste or adhesive To hang 24 strips over a 40 ft (12.19 m) perimeter Enough for 8 rolls per the paste guidance
Lining paper, if walls need it To cover 40 ft × 8 ft of wall, 320 sq ft (29.73 sq m) Rolls totalling at least that coverage
Seam roller For 24 strip joins 1
Snap-off knife blades For trimming 24 strips top and bottom 1 pack
Wallpaper smoother For every strip 1
Paste brush or roller To cover a 108 in strip evenly 1
Sponge and bucket For wiping excess paste from each strip face 1 set

Order of work

Prepare the walls first: strip any old paper, wash off paste residue, fill and sand defects, and hang lining paper if the surface is uneven or porous. Let everything dry completely, because a nursery timetable rarely allows for re-doing a wall that was papered while still damp underneath.

Cut and number the first several strips at the 108 in (274.3 cm) length, marking the top of each and noting where the pattern sits so the match is consistent. Begin beside the door or in the least prominent corner, hang the first strip plumb with a level rather than trusting the corner, and work around the 40 ft (12.19 m) circuit in one direction. Trim tops and bottoms in place with a fresh blade, roll each seam once, and wipe paste off the face of the paper before it dries.

The arithmetic behind repeats and strip yield is explored further in wallpaper pattern repeat explained.

Mistakes specific to this project

Estimating wallpaper by wall area, as if it were paint, is the fundamental nursery mistake. The walls here total 320 sq ft (29.73 sq m), and an area-based guess would suggest far fewer rolls than 8, because it ignores both the 108 in cut length and the fact that only 3 strips come out of each roll. Strips, not square feet, are the currency of this job.

Ignoring the repeat is the second error. A plain paper with no match could be cut at almost any length; this design forces every strip to surrender length to alignment. Change the repeat and the whole estimate changes, even though the room has not moved an inch.

Mixing dye lots is the third trap. Eight rolls bought in two trips may carry different batch numbers, and a slight colour shift that is invisible in the shop can show clearly across a corner in daylight. Buy all 8 rolls together and check the batch codes match before opening the first one.

Finally, in a nursery specifically, do not rush the drying. Paste fumes and a freshly papered room are not a place for a baby to sleep the same night. Finish the papering, ventilate the room well, and let the paper cure before the cot goes back against the wall.


Next step: choose your own paper's repeat from its label, run your room's perimeter through the Wallpaper Calculator, and pick your starting wall before the first strip is cut. The plan made here is the part of the job that cannot be improvised later.